Su Bazlı – Selülozik – Sentetik

Bu yazıda kısaca bu üç kavram ele alınacak ve bazı önemli noktaların altı çizilecektir. Ahşap, plastik ya da metal bir parçayı boyama ve ardından vernikleme aşamasında pek çok çeşit malzeme içinden tercih yapmaya çalışıyor olabilirsiniz. Bu aşamada da bu kavramlar mutlaka karşınıza çıkıyordur: Su bazlı – Selülozik – Sentetik Öyleyse Devamı…

Mini Bookcase

Steps: 1- I have cut 4 pieces. Dimensions: Base piece: 200 milimeters width, 100 milimeters depth and 18 milimeters thickness Side pieces: 150 milimeters width, 100 milimeters depth and 18 milimeters thickness Back piece: Exactly to cover the back side of the bookcase. In my case, its width is about Devamı…

Wooden Key Holder

Steps: 1- I’ve cut wooden laths in order to have 6 pieces of wood. I’ve cut them by my temporary fix as you see it’s actually an inverted jigsaw. 2- After pieces have been cut, now it’s time to use mitre saw. At this step, I have to say that Devamı…

Hotel Keychain

Steps: 1- I’ve prepared the wooden logs as small and circular as far as possible. Then sanded them. The actual diameter of a log is about 40 milimeters. 2- I’ve prepared the numbers from 1 to 24 as they will be the indicators of rooms. This step can be done Devamı…

[Project] Wooden Pot

I’ve used wooden lath for this project. Cut into pieces and then had some glue on each piece & joined them. For the ones who want to try this, I can say that you should use something for the water sealing inside the pot. Because by the time, water spoils Devamı…

[Project] Backyard Cabinet

​I had a backyard full of knick knacks and it was a total mess. I’ve decided to tidy it up and made this temporary cabinet. As a material, I’ve used wooden lath and insulation blocks. Wooden lath is for the frames, insulation blocks are for the surfaces. Not the best Devamı…

[Project] Antique Frame with Dried Flowers

Step 1: I’ve assembled four pieces of thin wood by cutting the endpoints 45-degree angle. Used glue and wood connector brackets on rear side. After that, I applied some plaster on the frame to fix minor roughness. Then painted the frame greenish and scratched to show it antique. Step 2: I’ve placed passepartout, the Devamı…

[Project] Medieval Age Axe

Step 1: First, I’ve taken out the old plastic handle and cleaned the surface. Then measured the space between the endpoint of the axe and the handle. Cut two pieces of wood with a wolf figure for the handle. Step 2: I’ve attached the wood pieces to the metal handle Devamı…